1. Before processing each program, it is necessary to strictly confirm whether the installed tool is consistent with the program.

 

2. When installing the knife, it is necessary to confirm whether the length of the knife and the selected clamping head are suitable.

 

3. It is forbidden to open the door during the operation of the machine tool to avoid flying tools or workpieces.

 

4. If a tool collision is found during processing, the operator must stop immediately, such as pressing the "emergency stop" button or the "reset button" button or adjusting the "feed rate" to zero, etc.

 

5. In the same workpiece, it is necessary to keep in the same area every time the tool is set to ensure the accuracy of the CNC machining center operation rules when the tool is connected to the tool.

 

6. If you find that the machining allowance is too much during the processing, you must use "single block" or "pause" to clear the X, Y, and Z values to zero, then manually mill them off, and then shake them back to the "zero point" to let them automatically run.

 

7. The operator is not allowed to leave the machine tool or regularly check the operation status of the machine tool during the automatic operation. If it is necessary to leave halfway, the operator must designate relevant personnel to check.

 

8. Before the light knife oil injection, the aluminum slag in the machine tool should be cleaned to prevent the aluminum slag from absorbing oil.

 

9. Try to use air blowing in the roughing program, and spray oil in the light knife program.

 

10. After the workpiece is off the machine, it must be cleaned and deburred in time.

 

11. When off duty, the operator must do a timely and accurate handover to ensure that the follow-up processing can proceed normally.

 

12. Before shutting down, ensure that the tool magazine is at the original position, and the XYZ axes stop at the center position, and turn off the power supply and the main power supply on the machine tool operation panel in turn.